Zak's Picks and Tricks // Fixing Stringy or Weak Prints

Posted by Zachary Tassler on April 06, 2016. 0 Comments

 

 Hey Guys,

Today I wanted to discuss something that a few people asked me about recently. Sometimes your prints can come out stringy, or with gaps between the layers. This is often due to incorrect filament diameter settings. This video briefly shows you how to properly adjust these settings and 9 times out of 10 this will fix your issue!

Check us out on Instagram @Wanhao_USA

and like our Facebook page:

https://www.facebook.com/wanhaousa3dprinters

Comments

There are no comments

Post Comment